Thread jacket installation

Thread jacket installation

The thread jacket installation methods can be divided as Step 4 to go: drilling, tapping, installed, go to the tail.

Step 1: select thread jacket to match drill drilling machine parts. Note: The holes can not be drilled crooked hole length greater than the length of the thread jacket installation.
Step 2: When the screw holes drilled, and the second step is to use non-standard tapping tapping screw holes. Tapping screw hole thread can not attack crooked, if the screw hole is a through hole, will have all the tapping.
The third step: you want to make is to choose the thread jacket installation tool install threaded sheath into the screw holes. Note: To thread jacket installation, you can not put too much pressure on the installation tool, or wire thread insert will jump teeth, while down caused by the wire thread insert installation fails.
Step Four: Finally, the wire thread insert into the end of the wire thread insert wire thread insert no tail, tail wire thread insert after the installation is complete, have to use the threaded sleeve caudal peduncle thrust is the wire thread insert caudal peduncle thrust before the installation is complete. No tail, eliminating the need for this step.